Jeep Wrangler JL Track Bar Bolts 9/16" UPGRADE DEATH WOBBLE FIX Front or Rear

It's common knowledge that the factory track bar bolts on 2018-current Jeep Wrangler JL's are the poorest fitting, undersized, most inappropriate bolts for the purpose. Death wobble and shredded track bar bushings has been the result for many using the factory bolts. 

These bolts are meant to solve all of the issues with the factory track bar bolts to get the best fit possible. They also are a far better fit than any other aftermarket track bar bolts for JL's that's currently out there. 

Many other aftermarket bolts were an improvement over the factory bolts but still fell short of what they should be. Other kits bolts are too short, only 3", leaving a large amount of threads in contact with the bushings which was a huge problem with the factory bolts to start. They also are all too short to use with aftermarket track bar/sector shaft braces which are a common upgrade on JL's and also often include undersized M14 bolts with the kits. So if you are adding a track bar brace get a set of these appropriately sized bolts to go with it.

These bolts are 9/16" fine thread. They maximize the shoulder area in contact with the bushings and they minimize the thread contact to the lowest possible amount for the most perfect fit you can get. We sell them in 2 different sets so you can choose the set that will give you the best fit possible. The bolts are Grade 8 hardened, yellow zinc plated. They include Grade 8 hardened, yellow zinc plated washers and Grade 8 hardened zinc plated stover lock nuts. The quality of each component is the best that is available.

SET 1 fits: 2018-current JL front (without a track bar brace) or rear on all. This set includes (2) 3.5" long bolts. 

SET 2 fits: 2018-current JL front with a track bar brace on the frame side. This set includes (1) 3.5" long bolt for the axle side and (1) 4" long bolt for the frame side.